RUST CONVERTER

Description

Extreme Green Rust Converter is a water-based metal treatment that penetrates rusted surfaces, converting the rust to an organic matrix that can be safely painted, coated, galvanised or chromed without fear of rust re-appearing beneath the coating.

Extreme Green Rust Converter treats rust in pipelines and storage tanks and on vehicles and equipment.

Uses:

Extreme Green Rust Converter is ideal for treating reinforcing steel used in construction and for protecting plates, pipes, flanges, joints and structural members before installation.
It is widely used on farms to protect metal sheds and buildings, to treat corrugated iron roofs and irrigation equipment.
Ideal for use anywhere where you need to treat rust and paint over it .

Benefits:

Reduces equipment downtime, maintenance/replacement costs
Effective on wet and dry surfaces and in humid and damp conditions
Chemically combines with rust to form a tough organic matrix that bonds to the metal surface, inhibiting further corrosion.
Safe for users – does not contain any mineral acids, phosphates or solvents
The organic matrix formed by Extreme Green Rust Converter is a stable, non-flammable compound.
Metals treated with Extreme Green Rust Converter can be cut and welded without hazard to the operator.
Environmentally responsible – non-hazardous and biodegradable
Cost effective
Extreme Green Rust Converter works exceptionally well on heavily rusted surfaces that are impractical to treat by conventional methods or in inaccessible locations.

Point of Difference:

Extreme Green Rust Converter is safe for users as it does not contain any mineral acids, phosphates or solvents.
Extreme Green Rust Converter is a practical alternative to shotblasting and sanding techniques as it does not strip metal surfaces.

Directions:

Clean loose or flaky rust with a wire brush. Clean off surface contamination including chemical, salt, oil and grease with a high pressure water spray.
Immediately before applying Extreme Green Rust Converter, wet the prepared surface with a fine spray of clean water and allow any surface water to drain away.
Then Apply undiluted Extreme Green Rust Converter using a brush, roller or conventional airless spray.
Allow treated surface to cure 12-24hr.

For Heavily rust surfaces use a two stage treatment.

Stage 2 Treatment

Apply Extreme Green Rust Converter diluted with equal volume of water to the prepared surface.
After 30-60 mins apply a second coat of undiluted Extreme Green Rust Converter and wait 12-24 hrs for curing.

Remove all excess black residual dust from treated surface with water and allow to dry thoroughly before sealing or painting. This will prevent “bleed through”.

Apply Extreme Green Rust Converter using a brush, roller, spray or dip tank.
Surfaces treated with Extreme Green Rust Converter are fully converted when the surface turns blue/black – usually 12 to 24 hours after application.
Wash treated surfaces with water and allow to dry thoroughly before painting, coating or applying galvanised or chrome finishes.